Stone Master Molds Rubber Mold for Concrete, Western Quick Fit Corner Molds
Stone Master Molds Rubber Mold for Concrete, Western Quick Fit Corner Molds
$132.95
- Create stone panel corners approximately 3.75″ wide and in lengths of approximately 11″ and 8.75″ for easy installation
- Professional grade rubber mold will last for hundreds of pours
- Each of 3 mold versions has one-of-a-kind stones
- NO RELEASE AGENT necessary
- Matching Western Quick Fit flat molds available
- Optional corner plug sold separately
- Made in the USA
Stone Master Molds Western Quick Fit Stone Panel 1-Step Corner Mold
Western Quick Fit is a stone panel corner mold that will create dry stack stone panels that are all approximately 3.75″ wide, and in lengths of approximately 11″, and 8.75″ for quick and easy installation. The finished product/stone is approximately 1-1.5″ thick.
In addition, each mold is approximately 20″ in length by 13.5″ wide by 2″ deep (3.75″ deep at corner end) and makes approximately 1.25 linear feet/1.35 square feet of dry stacked stone. Matching Western Quick Fit flat molds are also available, as well as a Western Quick Fit corner plug for one-step corners, which is sold separately.
Our molds require NO release agent. This will save you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone molds.
Made in the USA, both materials and labor.
Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix for your Western Quick Fit Stone Panel Corner Mold:
This is one suggestion for mixing the concrete for the stone veneer panel molds. There are many other instructions available online, including videos.
BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing.
If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc.
A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble.
Finally, cure the concrete in the stone panel corner molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.
george hisle –
Very good mold
george hisle –
Very good mold