Stone Master Molds Rubber Mold for Concrete, Western Quick Fit Flat Molds

Stone Master Molds Western Quick Fit Flat Molds for Concrete

Western Quick Fit is a Stone Veneer Panel Mold that will create dry stack stone panels that are all approximately 3.75" wide, and in lengths of approximately 19.25", 11.5", and 7.5" for quick and easy installation. The finished product/stone is approximately 1-1.5" thick.

In addition, each Stone Veneer Panel Mold is approximately 21.5" in length by 20" wide by 2" deep and makes approximately 2.2 square feet of dry stacked stone.

Of particular importance, our molds require NO release agent. This will save you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone molds.

Available in 5 unique variations, with no stone repeats.  Check out our matching Western Quick Fit corner molds.

Made in the USA, both materials and labor.

Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix for your Western Quick Fit Panel Molds:

This is one suggestion for mixing the concrete for the stone veneer panel molds. There are many other instructions available online, including videos.

BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing.

If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc.

A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble.

Finally, cure the concrete in the stone veneer panel molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.