Stone Master Molds Rubber Molds for Concrete, Fieldstone 1-Step Corner Mold

Fieldstone, also known as Flagstone, evokes the charm and simplicity of European provincial stone architecture. Its irregularly shaped stones create a rustic and timeless beauty. Each stone is unique, adding to the overall character and authenticity.  Create stone ideal for all buildings, fireplaces, retaining walls, accent walls, etc., with our Fieldstone corner molds for concrete.

Fieldstone pairs especially well with stucco.

Each corner stone produced is approximately 1-1.5" thick. Each Fieldstone corner mold for concrete makes approximately 1.75 linear feet with a grout joint.

A corner plug can be used (sold separately) for 1-step corners, or you can create your own from melamine, plywood, etc. 1-step corners allow you to pour the corners in one step. Pour the long, horizontal end first, place the plug on the mold, then fill the open, short end and lightly vibrate.

Our molds require NO release agent.  This will save you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone molds.

Available in 3 unique variations, with no stone repeats.  Additional versions available on request.  Matching Fieldstone flat molds are also available.

Made in the USA, both materials and labor.

Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix for your Fieldstone molds:

This is one suggestion for mixing the concrete for the Fieldstone molds. There are many other instructions available online, including videos.

BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing.

If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc.

A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble.

Finally, cure the concrete in the Fieldstone molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.