Stone Master Molds Rubber Molds for Concrete, Stair Tread Mold, 44″L x 12″W x 2.25″D

Create your own concrete stair treads with Stone Master’s stair tread mold. The rubber mold itself is 47.25″ long, 16.5″ wide, 2.5″ deep, and weighs approximately 32 lbs.  This form will produce one stone textured stair tread measuring approximately 44″ long, 13″ wide, and 2.25″ deep, with chiseled edges on all four sides.

Save money and create your own custom colors using our professional quality rubber stair tread form.  This professional quality mold can be used for hundreds of pours with proper care!

Our molds require NO release agent. Consequently, this will save you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone molds.

Made in the USA, both materials and labor.

Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix for your Stepping Stone Molds:

This is one suggestion for mixing the concrete for the stair tread molds. Of course, there are many other instructions available online, including videos.

MOST IMPORTANTLY, BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing.

If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc.

In addition, a plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Next, vibrate molds to release air bubble.

Finally, cure the concrete in the stair tread form for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stair treads at 70 degrees or greater until ready.