Stone Master Molds Rubber Molds for Concrete, Cobblestone Paver Molds

Stone Master Molds Cobblestone Paver Molds for Concrete

Stone Master Molds Cobblestone Paver Molds create pavers with a beautiful cobblestone texture. Fortunately, you can choose from a total of seven versions of Cobblestone Paver Molds, the right tools to create timeless patios and walkways for foot traffic. Not recommended for driveways, as they are only 2.25" deep.

These professional quality molds will last you for hundreds of pours with proper care!

Our molds require NO release agent. This will save you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone molds.

We recommend using a high strength concrete mix of at least 6000 psi compressive strength, such as Sakrete PRO-X180 which reaches 8000 psi at 28 days. Find out more about us

Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix for your Cobbelstone Paver Molds:

This is one suggestion for mixing the concrete for your Cobblestone Paver molds. There are many other instructions available online, including videos.

BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete PRO-X180 which reaches 8000 psi at 28 days. Follow the manufacturer’s instructions for mixing.

If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc.

A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble.

Finally, cure the concrete in the Cobblestone Paver molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.